Electronics / microelectronics

These are key issues faced by design engineers and production
planners in electronics.
individual steps have to be integrated into inline production easily, rapidly and reliably. This makes light-curing adhesives an obvious choice. Within a few seconds they cure upon exposure to UV or visible light.

Application areas:

	Bonding and fixing during assembly DELO has developed and tested products especially tailored to the requirements of assembly processes
	Bonding in electric motors - magnet and rotor bondings Efficient product range for bonding magnets and rotors
	Assembly - adhesives for fixing SMD components DELO-MONOPOX MK096 is an SMD adhesive - optimized for high-speed processes as well as for manual production
	Ferrite cores: Easy, high-strength bonding with specially tested, anaerobic curing adhesives High throughput at low cost
	Fast and good: coil wire fixing with light-curing adhesives Fixing of coil wires with light-curing acrylates from the DELO-PHOTOBOND range.
	Sealing soldered contacts on short-stroke keys for operating panels and keyboards By using the light-activated adhesives DELO-KATIOBOND, efficient production methods are possible
	Chip encapsulation compounds for consumer products With consumer products, such as electronic toys, product viability depends on production economies
	Fixing soldered contacts The adhesive provides secure protection against unsoldering and strong shocks